INVISIBLE SPONGE BITSERTS
will automatically pump water to your grinder bit. Patented design
works without a sponge. These fit the Wizard IV, the 1981-2002 old
Wizard, all Aero and Impulse models as well as all Wiz and Wizling
grinders made after 1996. Choose 3/4" or 1" sizes. $6.95
use sponges to wick the water to your bit (see below for replacement
sponges). The sponge will fit in the rectangular opening at the top
of BitSert. These fit the Wizard IV, the 1981-2002 old Wizard, all
Aero and Impulse models as well as all Wiz and Wizling grinders made
after 1996. Available in 1" size only. $4.95
SPLASH GUARD (#3844) fits into the two holes in
the BitSerts above and channels the water thrown from the spinning
bit back into the water reservoir.
SPONGE (#3859) for all Inland
THUMB PUSHERS by
Inland (#3849) These are cute little soft plastic items that loop around your
thumbs and have special slots to hold your glass in place
while you grind.
LUBRICANT by Inland (#3581)
Apply a dab of Shaft Lube on your grinder motor shaft before sliding
the bit on. Helps prevent the dreaded seized bit issue that vexes grinder
users everywhere. The best $3 you can spend on your grinder. Small tube
will last most hobbyists nearly a lifetime.
(#2633) About the handiest accessory for grinder or saw. Plug the switch into
your outlet, your grinder into the switch and tap your toe. No more
reaching to switch your saw or grinder on and off each time you go to use
it. A major timesaver that is used in professional glass studios.